|
| 不同电流下钯触头材料熔桥行为研究 |
| Observation on Molten Bridge of Pd Electrical Contact Material under Different Current |
| 投稿时间：2016-10-13 |
| DOI： |
| 中文关键词: 金属材料 钯触头材料 熔桥 高速摄像 |
| 英文关键词: metal materials Pd electrical contact material molten bridge high speed video camera |
| 基金项目:国家自然科学基金(51461023, 51507075, 51267007,U1602275, U1602271, U1302272)、云南省自然科学基金(2015FA042, 2014FB164, 2010CD126, 2012FB195)、云南省创新团队项目(2012HC027)、云南省技术创新人才项目(2015HB024)、稀贵金属综合利用新技术国家重点实验室开放课题(SKL-SPM-201526)。 |
|
| 摘要点击次数: 2851 |
| 全文下载次数: 3117 |
| 中文摘要: |
| 用自制的电接触-高速摄像试验系统观测了钯触头材料在直流单分断模式下的电接触过程中的熔桥行为，用SEM分析触头表面形貌。结果表明，熔桥演化过程可分为熔桥形成、熔桥拉长和熔桥断开3个阶段，历时约2.08 ms；熔桥的形状有哑铃型和圆柱型2种，其尺寸为微米级，并且熔桥断开时具有针尖状的特征；熔桥行为会侵蚀触头表面形成具有熔池和凸丘等特征的表面特征；熔桥的直径和长度随电流的增大均呈现出先增大后减小的趋势，在熔桥形成之前可能有电弧出现，在DC 6 V的分断电压下，钯触头材料的理想工作电流不宜大于14 A。 |
| 英文摘要: |
| The molten bridge evolution behavior of Pd electrical contact material was investigated by the homemade electrical contact-high speed video camera system under the DC and break only operation mode, along with the measurements of SEM morphology on the contact surface. Results showed that the evolution of Pd molten bridge could be divided into three stages: the formation of the molten bridge, the extension of the molten bridge and the rupture of the molten bridge during the process of electrical contact. The duration of these three stages was about 2.08 ms. The shape of the molten bridge had two types, dumbbell and cylindrical, and the dimension of the molten bridge was in micron level. The molten bridge would develop a needle tip-shape feature when it was broken. The molten bridge would erode the Pd contact surface, leading to the formation of molten pool and convex. Both the diameter and length of the molten bridge would build up with the increase of current and then diminished with the continuous increase of current. Arc phenomenon would occur before the formation of the molten bridge. The ideal working current of Pd contact material should not exceed 14 A under a DC of 6 V. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
